Car Alarms: Car alarm jammed, alarmtek, dash area

Question
QUESTION: Having lost our remote, we suddenly had our Dodge Intrepid car alarm start flashing, not allowing us to start the motor for the past 5 days. The car dealarship and our local mechanic haven't been able to help us.
ANSWER: Please tell me what you are experiencing.

I need to determine whether it's a factory alarm
issue or, if it's an aftermarket system you are
dealing with.

Is it: Headlights flashing, car horn honking
and a worded SECURITY" light in the dash flashing?
Or,
Is it: flashing parking lights,
an LED in the dash area, and a siren
"going off"?

Let me know more on this to better
advise you on a course of action.

Best Regards,

Robert Martin
CEO/ALARMTEK
DELUXESERVICE.com

---------- FOLLOW-UP ----------

QUESTION: The security system seems to have been factory installed; we did not have it put in separately. The head & tail lights are both flashing along with the red bulb above the light switch on the right side of the dashboard. No horn noise has occured or warning/security word indicated.

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart
(Go to: www.vehiclewires.com)
for the vehicle, and reverse engineer it wire
by wire, until safely removed.

If it does not work out this way,
you will have to replace the system
with one you know how to operate
and what to expect. Don't want to
get stuck in another bad situation.

Let me know what happens.

Robert Martin/CEO-ALARMTEK
DELUXESERVICE.com