Car Alarms: removing alarm, valet mode, starter wire

Question
i have 94 toyota pickup..when i bought it last april the seller did not have his remotes for alarm and it was in valet mode..i was just going to leave it like that but today i had a bad battery and when i installed a new one it reset the  alarm and now i cant control the alarm..i am in  the process of trying to remove it but my truck will not start..i disconnected all the wires that were spliced in into ignition and removed plug from alarm box it is a code alarm pro 3000..so now i have all those wires everywhere and my truck still will not start..there is a safety switch for my clutch but i dont see any wires from alarm going to it i even tried the clutchcancel button still it doesnt start..please help

Answer
The starter wire in the truck's ignition column
is black. Locate this wire, and re attatch the
2 ends. You should be able to start the engine once
done. I would then repair all open wiring that
you have there, and tape off.

That should solve the issue.

Good luck.

ALARMTEK