Questionthanx for reply,sorry i should have give more details. ok car has keyless entry from factory and anti-theft system and alarm,but i am installing CRIMESTOPPER alarm/keyless entry/remote starter,everything works exept i need to hookup new alarm's wire to factory anti-theft disarm wire.,so they say when i remote start car it sends signal to disarm anti-theft.my problem i cannot find disarm wire on car,so i can finish installation.can u please tell where that wire is and what color it is???thanx a lot.
-------------------------------------------
The text above is a follow-up to ...
-----Question-----
hello,thank u for being there.my question is about factory anti-theft disarm wire. What color code and where it is located on toyota siena LE 2000. Hope you can answer my question. Thanx
-----Answer-----
There is no wire you can use to
disarm the factory system. It works with
the locking and unlocking of the doors.
You will have to use the key, or add keyless
entry to the vehicle to handle arming and
dissarming. Sorry, but no quick fix
other then this that I know of.
Good luck.
ALARMTEK
AnswerAH,
ALLRIGHTY THEN, PLEASE LOCATE THE
BLUE (-) WIRE IN THE 20 PIN PLUG
AT FUSE BOX OR DRIVERS SIDE KICK PANEL,
AND USING YOUR (-) NEGATIVE OUTPUT WHEN RUNNING
WIRE (ALSO USED AS FACTORY DISARM), AND
CONNECT THE TWO. THEN ARM AND REMOTE START.
THEN IT SHOULD RECIEVE THE GROUND PULSE WHEN
THE ENGINE IS REMOTELY STARTED, DISARMING
THE OEM SYSTEM. :)
A.
