Car Alarms: instilling & resetting keyless entry, ford taurus, dash area

Question
I have a viper in my 1999 ford Taurus. the keyless entry went nuts and i had to disconnect it. what i need to know is how to hook it back up and reset the keyless entry

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm.

Repeat these steps to go back to armed
or usable mode.

Have a nice weekend.

ALARMTEK