Car Alarms: help on a INWELLS 3305 alarm, wire interface, power locks

Question
i have a 95 neon i got the alrm hooked half way up but i am have Problems with the unlocking and locking of the doors.Yes i have power locks and they work fine.i have the panel off there are 5 wires on the lock  switch middle one i know for sure is a 12v con. but this dig i have here has things like
NO,C,NC,No1,C1,Nc1 whats this about..
from my alarm dig looks like this:

org--NO
white-C
Yellow-NC
org/blk-No1
yell/blk-Nc1

? help thanks


Answer
The 1995 Neon uses a 5-wire interface to control locking and unlocking.  If you read this http://www.the12volt.com/doorlocks/page3.asp#5w it explains how to interface with your door locks using relays.  The NO, C, NC, NO1, NC1 refer to points on those relays.  When using the diagram shown in that link you do not have to concern yourself with pins 85 and 86 as these connections are made internally on your system.  Pin 87 refers to C (common), Pin 87a refers to NC (normally closed), Pin 30 refers to NO (normally open).  

So...

The white wire goes to a fused +12V supply.

Once you have found the door lock wires in the car you need to cut them, one is lock one is unlock.  Put Pin 30 (NO Orange) to the actuator side of either lock or unlock (you do not mention which is which in your post so read the manual to determine this).  Put Pin 87a (NC Yellow) to the other end of the cut wire that leads to the switch.  Then follow the same thing for unlock but use the pins labeled as NO1 and NC1.

Hope this helps