QuestionI just put a remote start in a 92 acura vigor, that part works great but I cant figure out the door locks. According to the diagrams I found the lock wire is green/white and the unlock is green/red. I found both these wires and probed and cut them just to make sure they were the right ones. Each wire shows 4.x volts at rest, and 10.x volts when lock or unlock is pressed. From my info they are type b door locks. How would I wire my negative lock and unlock wires to this? Thanks for your time!
AnswerYOURS IS A 3 WIRE NEGATIVE DOOR LOCK SYSTEM
AND WILL BE ABLE TO BE STRAIGHT TAPPED
DIRECTLY FROM YOUR ALARM/KEYLESS ENTRY SYSTEM
WITHOUT THE USE OF ANY EXTERNAL RELAYS.
TO DO THE BEST TEST, USE A SIMPLE TEST LIGHT,
GROUND THE CLIP TO THE CHASSIS, PIERCE THE WIRE.
ONCE THE WIRE RECIEVES A GROUND SIGNAL, IT
WILL ACTUALLY THROW THE LOCK OR
UNLOCK. SIMPLY TAP THE (-) OUTPUTS TO
THESE WIRES ACCORDINGLY, AND THAT'S THAT.
GOOD JOB ON THE REST!
ALARMTEK
USCARALARMS.COM
