Car Alarms: 98 intrepid power door locks, power door locks, fuse panel

Question
I am installing a Prestige APS-255CH in a 1998 Dodge Intrepid.  The alarm is in and working fine, however I am having a problem with the door locks.  The information that I have found elsewhere on the internet said that both wires from the alarm should be connected to the same white/green wire on th back of the fuse panel.  First of all there are two white/green wires.  I tried both with no luck.  I did use the resistors that I was told to also.  I can't seem to make it work.  Do I need to build a relay circuit for this or should I connect directly to the door switch.


Answer
You will need relays for this.
see positive relays at www.relayhelp.com
and then using one of the white/green wires found,
use a 2.7K (2700) ohm resistor (on pin 30)
& for lock and 620 ohm for unlock
(on the second relay-pin 30, tapped
about 1/2 in appart on the same wire.

That'll do the colocks correctly.
For more support, either call your seller for
help on they're sale, or try my site at
www.INSTALLSUPPORT.com where you can get
help for free. I only provide this level of support
for my own equipment buyers, but the guys
in the forum should be able to help if more
is required.

Good luck with it.

ALARMTEK