Car Alarms: ReSetting Viper Alarm with Remote, dash area, button spring

Question
We did this a few months ago, but I lost the instructions....  We
found directions for resetting my viper alarm using ONLY the
keyless remote, no need for the toggle switch.  It was a button
sequence, just hoping you could help?  Do you know how to do
this?

Thanks

Answer
No sorry, I don't have the remote setting instructions.
Here is the traditional way:

Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, locate, press and hold in the
valet/overide button, found under the
dash area, (push button, spring loaded)
until the installed LED (the blinking light)
in your dash area goes on solid,
and the siren chirps once.

(Your valet switch might be the toggle
(on/off) type. in this case, key on,
flip switch in opposite direction,
then turn the key off.)

This should reset the alarm, and reset
the grounded relay on the starter wire,
allowing you to start the engine.

At this point, the only thing working would
be the keyless entry from the alarm,
if it came equipped that way.

Just Repeat these steps to place it
back to usable armed mode.
You may get 2 chirps, confirming it,
and the lights may flash twice as well.

That should do it.

Good luck.

ALARMTEK