Question-------------------------
Followup To
Question -
hello, I'am installing a remote start/alarm in my explorer sport 1998,anyway I have ignition1A(+) LT.GRN/VIOLET HOOKED UP BUT WHAT DO I DO WITH IGNITION 2A(+)GRY/YEL AND IGNITION 2B (+) BLK/GRN, DO I NEED TO HOOK UP ALL THREE AND IF SO HOW WHEN i ONLY HAVE 2 IGNITION WIRES COMEING OUT OF THE ALARM MODULE? HELP PLEASE, THANK YOU!
Answer -
I don't recognise the system you are
attempting to install here.
I think you need to contact the people you bought it
from for support on the product they sold you.
Sorry, but I stopped providing support
services to my competitors customers awile
back. Rather then gues at it, I again suggest
you contact them for assistance on they're
equipment. You can also try to find
some help in my forum pages.
Go to www.INSTALLSUPPORT.com if
you want to post this question.
Good luck.
ALARMTEK
HELLO AGAIN, THESE ARE THE WIRES ON THE IGNITION SWITCH, I just want to know do i need to hookup the 2a-2b and if so togather or through a relay or what,you or whoever sends the wireing diagrahms out told me that these are the colors of my ignition switch and they are correct,my question is ,I have the ignition 1a lt grn/violet hooked up to my module but do I need the other 2 ignition wires coming off my switch both hooked up? and if so how do I do that, I only have 2 ignition hookups coming out of my alarm. thank you!
AnswerOk, yes you will need
the following connected. Check the setting
for the system you are installing
to do the third igniton, or you will
need to add a relay (POSITIVE) to the
second ignition output, to make the third.
Ignition #1: L GREEN/PURPLE IGNITION SWITCH HARNESS
Ignition #2: GRAY/YELLOW IGNITION SWITCH HARNESS
ENERGIZES THE HEAT/AC
Ignition #3: 2ND GRAY/YELLOW IGN. SW. HARN.
(CONTROLS THE BLOWER & AIRBAG)
As you can see all need to be used so that
when you remote start the engine & tranmission
runs right, and when engaged the heat or acc
are powered as well, you also have another
accessory wire that needs to done as well that
controls the heater too. Itt's BLACK & light green.
I hope this clears that up. See all relay
applications at www.relayhelp.com, For any
procedural/programing questions on the alarm
you have, try the seller. I don't know the system.
Good luck.
ALARMTEK
