Car Alarms: Viper Car Alarms, viper car alarms, viper car alarm

Question
Hello I am having problems with my car alarms and wondering if you can help me fix it.  The car is a 2000 Jeep Wrangler with a Viper Car Alarm,  I found 2 sensors, but there may be more I do not know much about the alarm.  I was installing a audio system and I took of the positive terminal of the battery, now the alarm goes off when I put it back on.  I no longer have the remote.  And the car won't start. I have disabled the siren becuase it was constantly going off.  What can I do to disable the whole alarm so I can drive it again.  THANK YOU.  I'd greatly appreciate a response.

Jeff Rieger

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.
If you want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
STARTERDISABLE.com