Car Alarms: window roll up, prooves, plug ins

Question
The window module only has one input for triggering that is why I suspect it.  I have gone over the other connections to the motors etc and cannot find anything.

-------------------------
Followup To
Question -
I recently installed a alarm system and a power window module.  When I arm My alarm Sometimes only one window rolls up, I have to disarm and rearm to get the other window to roll up.  Is this indicating a bad module?
Answer -
Sounds like a wiring conflict. Or a bad connector.
If intermitent, go over all connections, grounds,
plug ins etc.. to make sure it's not in the assembly.
At thi point if you can not correct the malfunction,
I would THEN look into the module being the culprit.

Normally though, it seems that it is the human factor
in the install phase that modules go "bad". Could
be anything from a bad crimped conector, to
a wire that cam undone,, on not well grounded.

Have a look at your work again and let
me know what turns up.

Have a good weekend,

ALARMTEK
CARPROTECTOR.com

Answer
Then if it's within your means, get a replacement
module and plug it in. If the other prooves to be bad,
then you will know it right off. I would however
fuse the power lead just incase the module
did recieve a surge or a short, you do not want it
to happen again. Then if it was the module, see
about a refund.

Good luck.

ALARMTEK