Questioni am installing a nitro bmw 2-way alarm in my 92 civic si. the car does not have power door locks already so i am trying to hook them up to the alarm. i have the lock motors and the 30a relays for each. the only thing i can'not figure out is how to hook everything up. the alarm harness for the locks is a 6pin plug. there is only a picture showing what the wires are. there are 3 locking and 3 unlocking. the 3 of each are nc, co, and no. the picture says normal close node, common open node, and normal open node. do you have any diagram or can you tell me how i would go about hooking up the relays to the alarm harness.
thank you for your time
AnswerIf the actuators are 2 wire, you need to
set up that Taiwanese system to do POSITIVE locks.
If 5 wire actuators, se 5 wire door locks or
the pick for it in the manual.
I have run across this alarm by many names
and that manual is poorly writen, and
difficult to understand. Specifically the little
red wire that says "oil lamp". This actually is
the tach reading wire, and MUST be attatched to
the tach under the hood or the starter will
continue to crank, and will cause damage.
In any event, from this point, you need to
contact CMT TRADING or ASIAN WOLF for these
knock off systems, and the support for them,
since I don't sell them here, and they do not
pay me to do that service on they're sales.
Good luck with it.
ALARMTEK
