Car Alarms: Lost Remote Fob, valet mode, key fobs

Question
I have 92 SC400 Lexus and don't have the key fobs to turn the alarm off. I have located the valet switch under the dash, but putting the car in valet mode does not work. The LED still flashes and car won't start.  I know nothing about disarming kill switches, but I just want to pull out all the wires, so that i can move my car so it won't get towed...
You think you can help me?

Answer
Ok, try this.
Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

If remotes are lost, they can be replaced in
most cases. I would need the FCC ID # off of
the brain box under the dash to ID the system.

That should do it.

If you still want to remove it at this point,
take it to your neighborhood installer
for this, or buy the wiring chart for
the vehicle, and reverse engineer it wire
by wire, until it's safely removed.

Let me know what happens.

ALARMTEK
WIREWERX.com
KEYLESSCAR.com