Car Alarms: dead car with new battery, jeep grand cherokee, dash area

Question
i have a 93 jeep grand cherokee i put in a new battery about 2 months ago. i went to start it and it didn't start the lights were flashing the alarm was making a clicking sound inside of the car it has no horn so it was not honking. now the car has no power at all. how can i totally disengage the alarm for good? how can i get my car to start again?

Answer
Ok, try this.
   Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area in most cases,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.

Let me know what happens.

ALARMTEK
CARALARMSALES.com