Car Alarms: viper car alarm, dash area, flip switch

Question
I believe that the clicker on my key chain no longer works and I'm unable to start my car. Luckily, my window was down when the problem began so I'm able to get into the car but I cannot start it becuase the ignition is disabled due to the alarm and I'm unable to disarm it. Any suggestions?  

Answer
Ok, try this.
   Put the key in the ignition, and turn forward
all the way just before cranking. Then within
5 seconds, press and hold in the valet/overide
button, found under the dash area in most cases,
until the installed LED (the blinking light)
in your dash area comes on solid.
(Your valet switch might be the toggle (on/off) type.
in this case, key on, flip switch in oposite direction,
key off.)

This should be valet. This overides
the starter kill relay in the alarm harness,
and returns the car back to disarmed mode.

The only thing that will work now on your system,
is the keyless entry if installed.

Just Repeat these steps to rearm your system.

That should do it.

Let me know what happens.

ALARMTEK
AUTOPAGER.com