Car Alarms: MVS-0 Integralok, side kick panel, wire colors

Question
I've purchased a MVS-0 Integralok. The instructions are very basic and lack detail. Given the following sentence, "INTEGRALOK CIRCUIT-J2-Pin#2 BEIGE WIRE (+)POSITIVE TRIGGER must be connected to trigger circuit in vehicle."

Question: What specifically is the "Trigger Circuit?"  

Answer
Well it's interesting and vague, lol.
(that's normal)

Door trigger wires and polarities
will very. It depends on the vehicle
but FORDS are the ONLY vehicles that use
(+) POSITIVE door triggers. Does this device
also provide a (-) negative door trigger?

If so, what's missing is the coresponding wire colors
polarities and locations in your vehicle
to interface the product.

I sell the wiring charts for most vehicles at
www.wirewerx.com, and it would help you
alot to see what goes to what and where.

If not, then it was designed for a FORD, and the
wire in the car or truck you need is normally a
black/blue striped wire in the drivers side kick
panel area. In either case, the manufacturer
or the reseller you bought it from should provide
some tech support on this. If not, I would
be a bit skepticle and leary of installing it.

Good luck with it.

ALARMTEK