Car Alarms: unistallation of alarm?, python car alarm, valet mode

Question
how do unistall a python car alarm? or just disconnect it  so i can get my truck to start again?  the battery went dead and it triggered the ingnition kill  and i can get it to start!  

Answer
Hmmm, bad news if there is no power, you will need
to locate the box and remove it. Under the dash
you will see a valet switch. Possibly close to the
left side foot panel area (common).
Once you restore power, and the alarm is going
off, locate this switch, turn on the ignition, and
then press and hold the valet button, until the
alarm responds and disengages (VALET MODE)
Just repeat the steps above to re-alarm the system
for normal operations.

Now you can start the car. Then I would contact Python  (www.directed.com) to get info to reverse engineer the system.  If you want to get the wiring for the truck
and do it yourself, go to www.wirewerx.com

Luck with it.

ALARMTEK