Questioni installed a valet model #562t remote starter.in the directions for the door locks it shows 2 wires 1-green (-)lock (+)unlock 2-blue (+)lock (-)unlock. i dont know how to hook these to my door locks i got as far as getting them to unlock but i cant get them to unlock.
AnswerThe reason the wires say (_) & (+) are that they are
setup to work in cars with negative or positive type door lock systems.
Yours are negative, but tricky.
The lock and unlock wires are POWER LOCK|gray/black |-|@ relay above gas pedal & POWER UNLOCK|blue/white |-| @ the black plug, in the drivers kick panel.
Blue/white at the relay DOES NOT DISARM FACTORY SECURITY! Remove silver module in drivers kick panel. Reach into recess, pull out harnesses. Two blue/whites in black plug. Test the one which is one pin from the corner, shows (-) pulse when door unlocked with key. Very short pulse disarms without unlocking. Remote starting will trigger factory security. You will need to disarm it too. See DISARMING FACTORY ALARMS at www.relayhelp.com.
Good luck with it. And if you run into more trouble, contact the people you bought it from for support, as I only support the products bought in my stores,
and I do not sell Valet. Have a good one.
ALARMTEK
www.UScaralarms.com
