BMW Repair: 95 bmw 325i, speed sensors, bmw 325i

Question
-------------------------
Followup To
Question -
not getting power to fuel pump fuse!!plz help me out
Answer -
replace the fuse (even if it looks good) pull the relay out and check for voltage while cranking; no voltage implies the problem is in the electrical feed to the fuesbox (chase the positive wire back to the problem location) if you have voltage at the relay, and you get a signal voltage only during cranking then the problem is the relay or wires leading to the pump. did you recently do any mods to the car or have anything replaced?  it's possible a line got pinched.  You can jump the relay to check the condition of the relay and you can put an ohmmeter on the wires to check for resistance.
let me know what you find out.
-cheers
scheidmiwa@hotmail.com




reply:
RELAY&FUSE ARE BOTH G00D...I PUT DERECT POWER TO FUEL PUMP..GETTIN GAS TO FUEL RAIL BUT CAR DIDNT START.HOW DO I CHECK THE REJECTER?  

Answer
whats a rejecter?
check and see if you have spark during cranking if not check the refrence sensor.  is the ignition on before you attempt to crank it over?  it's possible the cpu is bad if the pulses are not being sent to the injectors.  i'd check the engine speed sensors on the bell houseing of the tranny.
let me know more and i can help more.
-cheers