GMC Repair: window lift motor installation, panel fasteners, rear view mirror

Question
Need help installing a window lift motor for a 2003 GMC envoy

Answer
Hi
Remove the accessory switch panel.
Remove the 2 trim panel retaining bolts (1 and 2).
Use the trim clip remover in order to release the 9 trim panel fasteners from the door.
Remove the trim panel from the door.
Remove the inside door handle bezel.
Remove the outside rear view mirror (ORVM) switch, if equipped.
Loosen the regulator window carrier bolts.
Raise and support the window.
Disconnect the electrical connector from the regulator motor.
Loosen the upper 2 bolts that retain the regulator assembly to the door.
Remove the remaining 3 bolts that retain the window regulator assembly and the motor to the door.
Lift the regulator assembly upward in order to release the upper 2 bolts.
Rotate the upper portion of the regulator assembly forward.
Beginning with the lower portion, remove the regulator assembly through the door opening.
Place the regulator assembly on a prepared surface.
Remove the upper 2 bolts from the regulator assembly.
Remove the bolts retaining the window regulator motor to the window regulator.
Remove the window regulator motor from the window regulator.
That is the EXACT procedure per published data.
If more help is needed, follow post back
Good Luck
Pawl