Questionhow do i reset the keyless fob to my 2003 gmc quadrasteer. i have fobs from a 2000 gmc. at the dealership they say they will be the same, but they want $20 to reset. help if you can. russ. ps. do they make a repair manual for quadrasteers?
AnswerHi
Important
All transmitters which are to be recognized by the PDM must be programmed in a single programming sequence. When using this program method, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter.
The order in which the transmitters are programmed will determine its numbering position within the PDM memory. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. The number stamped on the transmitter case is for reference only; #2 can be programmed as #1, or vice versa. Additional unnumbered transmitters are also available.
1Close all the vehicle doors.
2Insert the ignition key into the ignition lock cylinder.
3Press and hold the door unlock switch.
4While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
6Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7Repeat the previous step to program up to 4 transmitters.
8Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.
9Operate the transmitter functions in order to verify correct system operation.
As far as Quadrasteer there is no SPECIFIC manual from GM, aftermarket I am not sure.
Hope this helps
Pawl
