QuestionQUESTION: The standard KD 2414 type tool is only applicable for removal. Installation requires a more efficient tool. What brand/tool is designed for installation. I used a tool once, but only found it to be useful for removal. I only need to replace the bearings so I dont have to pull the steering wheel.
ANSWER: Hello,
I have no idea of what you are talking about.
Don't know part numbers for lock plate tool. Bought if from Snap-on 20 years ago.
You did not state what kind of car and what your problem is.
---------- FOLLOW-UP ----------
QUESTION: The kd2414 is sold by many outlets and is the part number. I did state the type car, but somehow did not save. I have a 1988 Cadillac Eldorado 4.5 liter. I'm trying to get to the bearings just under the steering wheel lock plate. I have removed the lock plate including steering wheel before but did not find a tool for applying resistance to replace the lock plate and had to resort to manual strength which was only a partial remedy. I hope this explains a little better/
AnswerHello,
The bearings don't fail creating a loose column. The bolts way inside the column come loose by grabbing onto the column to get in and out.
Real common, I have fixed thousands.
You should not try doing this yourself. You will need a pivot pin remover too, but you will have a mess doing it yourself. It is truly an art to repair these columns. I don't do them anymore but if you write me at robo14@aol.com I can tell you who does.
You have already run across a problem reinstalling the lock plate.
You use the standard tool, but on tilt and tely you need to screw in a 5/16x18x1 allen bolt (you can get at hardware store) tighten down and then use lock plate tool. This keeps the shafts from seperating. Once lock plate is installed remove the bolt.
