QuestionI had my ac recharged and now the blower does'nt work in any mode. The compressor is working. The outside temp guage was inacurrate and some time before recharge went to two dashes. I am showing code ac1311. If I replace the outside temp sensor and clear the code is there a chance Things will work? Obviously the temp sensor needs to be replaced but once I do how do I clear the code? Could my mechanic have done something wrong when he recharged the ac. Is it true that proximity of the plug wires to the blower module can cause problems, they are very close.
Thanks for your help.
AnswerCheck the outside air temp wires that are located at the sensor that is located below the hood latch just aboy a few inches towards the passengers side behind the grill.
To clear the code AC1311:
1. Turn ignition to ON position ONLY, Do not start engine.
2. Simultaneously push and hold the OFF and WARM button on the inside display and hold for 3 seconds and release them.
3. After the codes pass and you see PCM?
4. Push and release the LO button 2 times and you will see ACM?
5. Push and release the HI button and you will see ACM CODES?
6. Push and release the LO button and you will see ACM CLEAR CODES?
7. Push and release the HI button and you will see ACM CODES CLEAR.
8. Wait 3 seconds and press AUTO.
9. Turn OFF ignition, wait 2 minutes and start engine.
Is it true that proximity of the plug wires to the blower module can cause problems, they are very close.
YES. it is.
