Chrysler Repair: P0760, 2004 chrysler sebring, transmission control module

Question
2004 Chrysler sebring. Had P0760 code back in may, flushed transmission and reset code. P0760 came back and replaced shift solenoid, reset the computer and one month later P0760 came back. Replaced shit solenoid once again and got P0760 again. what should I do? Electrical problem? IDK please help

Answer
Symptom:
P0760-OD SOLENOID CIRCUIT
When Monitored and Set Condition:
P0760-OD SOLENOID CIRCUIT
When Monitored: Initially at power-up, then every 10 seconds thereafter. They will also
be tested immediately after a Gear Ratio or Pressure Switch error is detected.
Set Condition: Three consecutive solenoid continuity test failures, or one failure if test is
run in response to a Gear Ratio or Pressure Switch error.

POSSIBLE CAUSES
RELATED RELAY DTC’S PRESENT
INTERMITTENT WIRING AND CONNECTORS
TRANSMISSION CONTROL RELAY OUTPUT CIRCUIT OPEN
OD SOLENOID CONTROL CIRCUIT OPEN
OD SOLENOID CONTROL CIRCUIT SHORT TO GROUND
OD SOLENOID CONTROL CIRCUIT SHORT TO VOLTAGE
OD SOLENOID
TRANSMISSION CONTROL MODULE