QuestionI have 1999 dodge stratus 2.5L engine and I would like to check the electrical connectivity from the hall effect sensor all the way to the 60-way plug at the controller. Do you know what color wire goes were?
Thank you
Is it The black/light blue goes to pin 4, the gray/black goes to pin 24, and the orange goes to pin 7, though each of them pass thru other disconnects along the way so if you don't get continuity on any of these wires you would want to check their respective disconnects.* (I read it from your other answer guy had problems with his 91 Plymouth Acclaim, 2.5L, automatic)
AnswerHi Nik,
The sensor ground wire is from pin 1 at the plug to pin 43 at pcm (black/light blue).
The signal is from pin 3 to pin 33 (tan/yellow).
The 8v sensor supply is from pin 2 to pin 44 (orange/white).
The spark coil driver is from pin 6 to pin 4 at the pcm (black/gray).
The distributor ground in on pin 5 (black).
The 12v supply to the coil is on pin 1 of the 2-wire plug (dark green/orange) but it will not show unless the sensors are pulsing which closes the points of the ASD relay.
Have you checked for codes using the ignition key:"on-off-on-off-on and leave on" doing that in 5 seconds or less elapsed time? Then watch for the mileage reading in the odometer window to change to show 4-digit number preceded by a P. The cam sensor is an 0340, the crank sensor is an 0320.
Roland
PS The '91 2.5L is a 4 cyl engine with no relationship to your V-6.
