Chrysler Repair: door panel removal, machanic, door switch

Question
2002 Chrysler T&C....the driver side window slowly went down by itself and won't go back up. The motor works but it's not catching the window. I've tried to remove the door panel but not having luck despite following instructions. I'm afraid to pry too much to get to the clips. If I seek professional help, would a body shop be better than a machanic?48

Answer
Here is the procedure from the '02 manual:REMOVAL
Remove the plug and remove screw attaching door pull cup to inner door panel.
Remove switch bezel and disconnect power window/memory switch.
Remove screws attaching trim panel to door from below map pocket.
If equipped, remove window crank. (Refer to 23 - BODY/DOOR - FRONT/WINDOW CRANK - REMOVAL)
Remove screw holding door trim to door panel from behind inside latch release handle .
Disengage clips attaching door trim to door frame around perimeter of panel.
Lift trim panel upward to disengage flange from inner belt molding at top of door.
Tilt top of trim panel away from door to gain access to latch linkage.
Disengage clip attaching linkage rod to inside latch release handle (INSIDE DOOR HANDLE LINKAGE).
Separate linkage rod from latch handle.
Disconnect the power door switch, courtesy lamp electrical connectors.
Remove front door trim panel from vehicle.

I believe if you follow this you can take it off yourself. A body shop would be more experienced and less expensive if you don't want to try it yourself.

Roland