QuestionQUESTION: Hello, thank you for reading this. About a year ago, the rear manual controls for the fan operation for the back fo the car stopped working but I could still control from the front so no problem. Then, the back would not blow from the console vents, just floor, so I would have to take the selector up front off of floor and dash to just dash and it would start working in the back so then I could put it back to floor and and it would work fine. Well, now, the front dash vent is the only thing that works in the front. It doesn't blow our of anywhere up front but the dash. Even when I put in on just floor, it stays coming out of the dash. Any idea what the problem is? fuse? Fan? Big or little problem?
ANSWER: which one would u like to look at U are talking about rear ones and front ones which one?
---------- FOLLOW-UP ----------
QUESTION: The front dash only has air coming out of the dash area, no floor vent at all. Even when I change the selector to full floor, it just stays coming out of the dash, no change. I am down to only dash air in the front. Thank you for your time!
Answer
pic
this is where the motors are find the mode door one make sure its working
Disconnect and isolate the negative battery cable.
Remove the silencer from beneath the driver side end of the instrument panel. (Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL SILENCER - REMOVAL).
Disconnect the wire harness connector from the mode door actuator (BLEND DOOR ACTUATOR).
Remove the two screws that secure the mode door actuator to the HVAC air distribution housing and remove the actuator.
1 - WIRE HARNESS CONNECTOR
2 - MODE DOOR ACTUATOR
3 - SCREW (2)
4 - DRIVER BLEND DOOR ACTUATOR (DUAL-ZONE)
5 - HEATER CORE
6 - BLEND DOOR ACTUATOR (SINGLE ZONE) OR PASSENGER BLEND DOOR ACTUATOR (DUAL-ZONE)
