Chrysler Repair: starters, negative battery cable, starter solenoid

Question
how to install a starter on a 2004 dodge intrepid with a 2.7 engine

Answer
REMOVAL
Disconnect and isolate the battery negative remote cable from remote ground post (NEGATIVE BATTERY CABLE).
Raise vehicle.
Remove three bolts attaching starter to engine (STARTER 3.5L).
Remove battery positive feed wire from starter.
Remove starter solenoid assembly from transmission housing. Position the starter to gain access to the Connector Positive Assurance (CPA) wiring connector.
Position jack stand beneath engine and slightly lift to relieve pressure from left engine mount.
Remove three left engine mount mounting bolts from engine block.
Jack engine up slightly to give more room to maneuver starter assembly.
Slide rear of starter motor out between catalyst and engine mount.
Disconnect posi-lock starter solenoid connector.
Remove the starter from vehicle.