QuestionYou said in a previous post there are a few tips for removing the starter from a 99 chrysler lhs. If you can give me any advice that would be great. Thank you very much!
AnswerHi Charles,
This is for the the 3.2/3.5 engines:
There are a few tricks: This is from the '98 manual but I believe it applies equally to your '99.
After disconnecting battery and raising the vehicle,
remove one nut on the catalytic support bracket.
remove two nuts from catalyst support bracket mounting.
remove two bolts and one nut attaching starter to engine
remove battery positive feed wire
remove starter solenoid assembly from trans housing
position starter to gain access to posi-lock wiring connector
position jack stand beneath engine and slightly lift to relieve pressure from left engine mount (use wood block spacer to protect pan)
remove three left engine mount mounting bolts from engine block
jack engine up slightly to give more room to maneuver the starter
slide rear of starter out between catalytic converter and engine mount
disconnect posi-lock starter solenoid connector
remove starter
Install is the reverse
Let me know if you have instead the 2.7
Roland
