Chrysler Repair: Location of EGR valve, electrical transducer, gasket surfaces

Question
Hello Kevin,
I have a 1997 Chrysler Sebring 2.4 L convertible.  The car had been idling rough, and I changed the plugs and wires.  A local auto repair store ran a test on it, and it showed the EGR valve to be faulty.  Where is the EGR valve and how do I replace it? Thanks for your help,  Stacy

Answer
Driver side of the motor up top.

EGR VALVE AND TRANSDUCER - 2.4L
If the EGR system operates incorrectly, replace the entire EGR valve and transducer together. The EGR valve and electrical transducer are calibrated together.

REMOVAL
Disconnect vacuum supply tube from solenoid.
Disconnect electrical connector from solenoid.
Remove EGR tube to EGR valve screws.
Remove EGR valve mounting screws. Remove EGR valve and transducer.
Clean gasket surfaces. Discard old gaskets. If necessary, clean EGR passages.
INSTALLATION
Loosely install EGR valve with new gaskets.
Finger tighten EGR tube fasteners.
Tighten EGR tube fasteners to 11 N·m (95 in. lbs.) torque.
Tightening EGR valve mounting screws to 22 N·m (200 in. lbs.) torque.
Connect vacuum supply tube to solenoid.
Attach electrical connector to solenoid