Chrysler Repair: headlight bulb replacement:99 Concorde/LHS/300M, halogen bulbs, hood latch

Question
how do i replace the headlight bulbs in my 1999 concorde

Answer
Hi Dave,
Here is the description from the manual:
REMOVAL
Release hood latch and open hood.
Remove large rubber grommet (70 mm x 168 mm) from splash shield to gain access to fascia fasteners Access Rubber Grommet
Remove fasteners attaching fascia to the front fender and splash shield, using access hole in splash shield Fastener Locations
Remove the push pins attaching the fascia to the upper radiator closure panel Remove Push In Fasteners
Remove jackscrews attaching headlamp housing to crossmember and remove the lamp housing to access the lamp(s) Headlamp Jackscrews
Roll fascia forward to clear way for headlamp housing removal Roll Fascia Forward
Disconnect wire connector from back of lamp socket(s) and/or bulbs.
Remove headlamp housing Remove Headlamp Housing
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.

Place headlamp housing into position.
Connect wire connector to lamp socket(s) and/or bulbs.
Verify headlamp and signal lamp operation.
Install jackscrews to attach headlamp housing to crossmember.
Align fascia to bumper reinforcement and install the top center push pins, to upper radiator closure panel.
Align the two fascia studs to the fender vertical attachments, at the same time align the fascia groove on the horizontal flange with the fender drive pin. Push fascia rearward to engage the fasteners.
Install nut on fascia stud through the splash shield access hole.
Verify headlamp operation and alignment

Let me know if something isn't clear.
Roland