QuestionQUESTION: I would like to know how to replace the Heater core in a 1996 Sebring LXI convertible V-6
ANSWER: Hi David,
The heater core can be replaced without removing the whole housing but if there has been significant leakage the manual suggests pulling the housing and cleaning it, which is a big job. Just removing the core is an 18-step process which I can type in and send to you as a follow-up answer, or I can xerox copy and postal mail you the entire procedure for removing the whole unit. Let me know which you want. Use the "thank/rate" tab below to get back without having to wait for me to be 'available' to take a question. There is a space for comments. While there, if you would consider nominating me for 'expert of the month' that would be appreciated.
Roland
---------- FOLLOW-UP ----------
QUESTION: please send me the 18-step process. The heater core just started to leek.Thanks David PS.I am retired mechanic but I do not have a service manual for this car.
AnswerHi David,
How did things work out with the heater core?
Earlier, last month, you asked me a question about that problem with your vehicle. Now I need to ask a favor of you. I am competing for the honor of being the "Expert of the Month" for December. You can help me by going the the 'thank/rate' tab below and look for the question that asks if you think I should be so-honored. If you would select the 'yes' option I would be most appreciative. Please do this before 6pm CST today, New Year's Eve when the competition ends. I wish that your Chrysler vehicle is running well and gives you good service in the New Year!
Roland
Hi David,
Here are the steps:
Disconnect battery - remote cable
Remove radio/control module bezel
Remove right instrument panel side trim
Remove two screws at lower right side support beam
Remove bolt for instrument panel supprt at A-pillar
Remove left instrument panel side trim
Remove upper instrument panel bezel
Remove lower knee bolster
Remove console screws at instrument panel
Remove gear shift knob
Remove shifter bezel
Remove console screws at rear, remove rear half of console
Remove front console screw, remove front half of console
Remove right side instrument panel support strut
Drain coolant
Remove heater hoses at cowl
Remove heater core cover screws and cover
Remove heater core.
Reverse to install.
Best of luck, and thanks for considering an 'evaluation'.
Roland
PPS The voting for 'expert of the month' ends tomorrow afternoon. If you would be so kind as to find the "nomination?" area of the 'thank/rate' tab and change the 'no' to a 'yes' that would give a vote. Thanks.
