Chrysler Repair: Replacing Headlight Bulbs, chrysler sebring convertible, chrysler sebring

Question
I own a 97 Chrysler Sebring Convertible and I have one headlight that is burnt out.  Can you assist me on how to replace the bulb?  I have a starset that I have removed the two screws on top, but the assembly will not pull out.  Also, the lens on both headlights have a yellow film on the inside of the lens.  Can they be removed from the assembly and be hand cleaned?  Your assistance and advise would be greatly appreciated to resolve these issues.

Answer
HEADLAMP MODULE
The headlamp module contains the park and turn signal lamps and is serviced as an assembly.

REMOVAL
Release hood latch and open hood.
Remove screws holding headlamp module to radiator closure panel and headlamp adapter Headlamp Module Screws
Separate headlamp module from radiator closure panel Headlamp Module
Disengage wire connector from headlamp bulb socket.
Rotate park/turn signal lamp socket one quarter turn counterclockwise.
Pull park/turn signal socket from headlamp module.
Separate headlamp module from vehicle.
INSTALLATION
Position headlamp module to vehicle.
Push park/turn signal socket into headlamp module.
Rotate park/turn signal lamp socket one quarter turn clockwise.
Engage wire connector to headlamp bulb socket.
Position headlamp module to radiator closure panel.
Install screws holding headlamp module to radiator closure panel.