Chrysler Repair: 98 TC start and stall, instrument cluster, range indicator

Question
I have a 98 Town and Country van.  It has the start and stall problem that so many of them have.  I have done a ton of research and belive that it is the loose welds on the instrument cluster which caused the totally crap anti theft system to activate.  It is my understanding that just resoldering these will fix it.  What I can't figure out is how to get to the instrument cluster.  I have heard from a friend that you just pry the large dash cover up and get in from behind the speedometer.  This is supposed to be easy to get to but I don't want to try it without directions from an expert.  Thanks JR

Answer
INSTRUMENT CLUSTER WITH ELECTRONIC TRANSMISSION RANGE INDICATOR
REMOVAL
Remove instrument cluster bezel Instrument Panel - Electronic Transmission Range Indicator
Remove screws holding instrument cluster to instrument panel.
Rotate top of cluster outward.
Remove instrument cluster from instrument panel.
Disconnect wire connector from back of instrument cluster.
Remove instrument cluster.
INSTALLATION
Place instrument cluster in instrument panel, bottom first.
Connect wire connector into back of instrument cluster.
Position instrument cluster in instrument panel.
Install instrument cluster mounting screws to instrument panel.
Install instrument cluster bezel.


INSTRUMENT CLUSTER BEZEL
REMOVAL
Remove steering column cover.
Remove over steering column bezel Instrument Cluster Bezel
Remove left end cover.
Remove screw at left end of cluster bezel and headlamp switch.
Remove screws holding cluster bezel to instrument panel from each side of steering column.
Disconnect clip holding cluster bezel to instrument panel from above right vent louver.
Separate cluster bezel from instrument panel.
Disconnect wire connectors from back of the bezel.
INSTALLATION
Connect wire connectors into back of the bezel.
Place cluster bezel in position on instrument panel. Use care not to place hands on louvers.
Connect clips to hold cluster bezel to instrument panel. Use care not to add pressure on the A/C louvers to seat the cluster bezel clips.
Install screws to hold cluster bezel to instrument panel on each side of steering column.
Install screw at left end of cluster bezel and headlamp switch.
Install left end cover.
Install over steering column bezel.
Install lower steering column cover