QuestionQUESTION: Kevin, Thank You in advance for the service you guys provide...I have a 2001 PT cruiser and both key fob's the unlock button has popped out. I bought two new ones from the dealer and wanted to know if there was a way to reset them with the old ones?
ANSWER: no sir U need to good working key fobs in order for u t program them your self U will need to visit the dealer.
---------- FOLLOW-UP ----------
QUESTION: Kevin, I do have two key fobs that work just the unlock button has popped out. The button does still work...
Thank you,
Joe T
AnswerCUSTOMER PROGRAMMING
Insert the key into the ignition switch, and turn the ignition switch to the RUN position (without starting the vehicle)
Using the RKE transmitter programmed to the RKE module, press and continuously hold down the UNLOCK button for 4-10 seconds.
Within the 4-10 second time range, continue to hold the UNLOCK button and press the PANIC button. Both buttons may then be released. Upon the PANIC button being depressed, the message for customer programming mode will be transmitted to the RKE module.
A chime will be heard to verify that the customer programming mode has been entered.
Press and release any button on each transmitter that is to be programmed to the RKE module, including any transmitters which were previously programmed to the RKE module (with a maximum of four possible) After each transmitter is successfully programmed, a chime will be heard to verify that successful programming of the transmitter has occurred.
After thirty seconds, or upon the ignition switch being turned OFF, a chime will indicate that the RKE module has exited the programming mode.
