Questioncar sat for 2months,,dead battery ,,replaced with 1000cca, new battery---car starts,,runs 7 seconds ,,then dies---same thing over and over---friend said alarm ,,not set ,,,trigger alarm,,,car starts and runs,,,drive 1 mile to get new gas,,,start car ,,,same thing,,,,10 cranks car runs ,,touch gas pedal dies,,,,start car ,,put in drive ,,the car rolls into parking lot,,,,had car towed home,,,the codes I got were # 1496---0122----0106----0405 --any suggestions the car ran fine ,,,got sick could not drive for two months---dead battery then this
AnswerIt sounds like something electrical. Your best bet is to bring it into a repair shop to have repaired I will tell you what each code means
P0122-A REPAIRING - THROTTLE POSITION SENSOR VOLTAGE LOW This is the sensor that tells the throttle how much it needs to open under the conditions. It is located on the throttle body of the engine and should have three wire going to the connector 1. power 2. ground 3. 5 volt reference wire that goes to the computer to tell it how much to open and close the throttle
P0106-A REPAIRING - BAROMETRIC PRESSURE OUT OF RANGE
P0405-A REPAIRING - EGR POSITION SENSOR VOLTAGE TOO LOW
P1496-A REPAIRING - 5 VOLT SUPPLY OUTPUT TOO LOW
Which code 1496 I think is where your problem is because thats the wire that sends the 5 volts to all these sensors which is the only code that is related to all three other codes and the other codes have nothing in common with each other except that they all run off this 5 volt reference wire
