Chrysler Repair: 98 window motor, screw holes, lbs torque

Question
QUESTION: I want to replace both passenger and driver window motor. My manual doesn't have directions on how to. Can you step me through the process and if it can be done without going to the shop?

ANSWER: 98  what??

---------- FOLLOW-UP ----------

QUESTION: Sebring convertible. I apologize for not mentioning that. Also my windshield leaks. I believe the problem is the trim along the side of the windshield (garnish trim). The trim strip is loose and I can push it down. Water actually drips through the door along the black water strips. How can I also fix this along with the window motor. Thank you

Answer
WINDOW MOTOR
WARNING: DO NOT HAVE ANY HANDS OR FINGERS IN SECTOR GEAR AREA WHERE THEY CAN BE PINCHED BY SMALL MOVEMENTS OF REGULATOR LINKAGE.

REMOVAL
Move the window to the 3/4 down position, if possible.
Remove door trim panel and window regulator, Refer toBody for removal procedures
WARNING: FAILURE TO CLAMP THE SECTOR GEAR TO THE MOUNTING PLATE WHEN REMOVING THE MOTOR CAN RESULT IN INJURY.

Disconnect wiring connector from motor.
Secure the sector gear and mounting plate with a C clamp or similar clamping tool. This will prevent a sudden and forceful movement of the regulator when the motor is removed.
Remove three mounting screws that hold motor gearbox to regulator Motor Removal
Remove motor from regulator.
INSTALLATION
Install new motor on regulator by positioning motor gearbox so that it engages regulator sector teeth.
A slight rotational or rocking movement may be necessary to bring three motor gearbox screw holes into proper position.
Install three gearbox screws and one tie down bracket screw, if applicable. Tighten to 8.4 to 13 N·m (74 to 115 in. lbs.) torque.
Install regulator, using the switch, test operation of motor.


DOOR TRIM PANEL
REMOVAL
Roll door glass down.
Disengage clips holding speaker grille to door trim panel.
Remove screws holding door trim panel to door Door Trim Panel Screws
Disengage clips holding perimeter of trim panel to door Door Trim Panel Clips
Lift trim panel upward and disengage trim panel from upper retainer channel.
Tilt trim panel away from door.
Disengage clip holding latch linkage to back of inside door handle.
Disconnect electrical connectors as necessary.
Separate door trim panel from door.
INSTALLATION
Position door trim panel next to door.
Connect electrical connectors as necessary.
Engage clip holding latch linkage to inside door handle.
Position door trim panel on door and engage trim panel to upper retainer channel.
Engage clips holding perimeter of trim panel to door.
Install screws holding trim panel to door.
Engage clips holding speaker grille to door trim panel.