Chrysler Repair: Spark Plugs on 2.7/3.2L engines, spark coil, dodge intrepid

Question
Where are the spark plugs located on a 98 dodge intrepid?  Thank you so much in advance for your answer

Answer
Hi Joyce,
There are three spark plugs on each cylinder bank on the V-6 engine, but because each plug has its own spark coil you will not see the plug until you remove the spark coil for it. To get to the plug you have to remove the spark coil.
First remove the wire connector to the coil. On the 3.2/3.5L engine coil you have to loosen the screws by alternating back and forth. Do not loose the spacers under the coil when removing the screws.
Remove the coil
Remove rubber boot from the plug
Remove the spark plug
Inpect the spark plug
To install:
Begin by installing plug by hand to avoid cross threading
Tighten plug to either 13 ft-pound (2.7L) or 20 ft-pound (3.2/3.5L)
Install rubber boot onto ignition coil
Install ignition coil and boot on spark plug
Install coil screws and tighten to about 5 foot-pounds (don't overdue and strip the threads however)
Conneect the electrical connector.
So look for three equally spaces devices on each cylinder bank and you will have found where the plugs are hiding.
Roland
PS Please rate my answer by using the "thand and rate tab" below. Thanks