Chrysler Repair: chrysler repair, radiator hoses, 2000 chrysler lhs

Question
QUESTION: where is the thermostat on a 2000 chrysler lhs?

ANSWER: engine size

---------- FOLLOW-UP ----------

QUESTION: where is the thermostat on a 2000 chrysler lhs 3.5

Answer
THERMOSTAT - 3.2/3.5L
REMOVAL
WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.

Disconnect negative cable from remote jumper terminal.
Drain cooling system.
Raise vehicle on hoist.
Disconnect electrical connectors from engine oil and power steering pressure switches.
Disconnect radiator and heater hoses from thermostat housing.
Remove thermostat housing bolts Thermostat and Housing - 3.2/3.5L Engine
Remove housing, thermostat, and gasket.
INSTALLATION
Clean gasket sealing surfaces.
Install thermostat and gasket into thermostat housing. For ease of installation, install bolts in housing for thermostat and gasket retention.
Install thermostat and housing to cylinder block. Tighten bolts to 12 N·m (105 in. lbs.)
Connect heater and radiator hoses. Install hose clamps.
Connect electrical connectors to engine oil and power steering pressure switches.
Lower vehicle and connect negative cable to remote jumper terminal.
Refill cooling system. Refer to Cooling System Refilling in this section.