QuestionI have a 2002 Chrysler Concorde LX. Electric motor on rear window, driver's side, quit working. How do I get the door panel off without ruining the interior paint?
AnswerREMOVAL
CAUTION: Do not pry on door trim panel, damage to trim panel will result.
Open trim plug from the pull cup and remote bezel by inserting a small flat blade tool into the notch and lifting up.
Remove screw in the pull cup.
Remove screw in remote bezel.
Remove three screws from the bottom edge of door (REAR DOOR TRIM PANEL - TYPICAL).
NOTE: Clips are reusable up to three times.
Using a trim tool, disengage the retaining clips from the door trim panel to the sheet metal inner panel, two clips at the rear of panel and one at the front of the panel (REAR DOOR INNER TRIM PANEL - TYPICAL).
Raise trim panel up over the door flange and being careful to hold the panel securely.
Disconnect the remote linkage from the door remote handle.
Remove the wire connect from the rear door speaker, if equipped.
Disconnect power window switch wire connector.
Disconnect wiring harness clips from the trim panel.
Disconnect the courtesy lamp, if equipped.
Remove trim panel from door
