Chrysler Repair: 1999 Chrysler 300M [replace front bumper], fog lamps, hood latch

Question
Hi. I have a 1999 Chrysler 300M. I want to change the front bumper. Could you give me any advice or steps on how to do this? Thanks.

Answer
FRONT BUMPER FASCIA - CONCORDE/LHS/300M
REMOVE
Release hood latch and open hood.
Remove large rubber grommet (70 mm x 168 mm) from splash shield to gain access to fascia fasteners Access Rubber Grommet
Remove fasteners attaching fascia to the front fender and splash shield, using access hole in splash shield Fastener Locations
Remove the fasteners attaching the fascia to the lower crossmember Remove Push In Fasteners
Remove the fasteners attaching the fascia to the upper radiator closure panel Remove Push In Fasteners
Disconnect wire connectors (fog lamps, parking/turn signal, side marker), if equipped Front Bumper Fascia
Remove fascia from vehicle.
INSTALLATION
Connect wire connectors.
Place fascia in position on vehicle, by fitting foam to bumper beam. Use care not to scratch fender. Tape may be put on fender for protection.
Install the top center fasteners, to upper radiator closure panel.
Install fasteners attaching fascia to the front fender and splash shield, using access hole in splash shield
Align fascia to bumper reinforcement.
Align the two fascia studs to the fender vertical attachments, at the same time align the fascia groove on the horizontal flange with the fender fasteners. Push fascia rearward to engage the fasteners.
Install nut on fascia stud through the splash shield access hole, on each side