Chrysler Repair: 1994 Lebaron, window switches, power mirror

Question
Hi, Could you please tell me. How to remove the inside door panel from the driver side door?

Thank You,

Answer
Hi Debbie,
I assume that you are speaking of a J-body convertible model. If not, let me know.
There are quite a few steps in the procedure:
Roll down glass and disconnect the battery
Remove screw holding trim bezel to inside latch release handle
Slide bezel forward to disengage hooks holding bezel to latch release handle
Separate bezel from door trim
Disengage wire connector from power door lock switch, if equipped
Using a trim stick pry upward at rear edge of switch panel to disengage clips
Separate switch panel from door trim
Disengage wire connectors from power mirror and power window switches, if equpped
Remove screws holding power seat switch to panel
Separate switch panel from door
Remove screw holding window crank to regulator spline and separate handle from door if equipped
Using a trim stick, disengage clips holding speaker grille to door trim
From above speaker, remove screw holding trim panel to door
Pry outward at bottom of courtesy lamp to disengage tabs holding lamp to trim panel
Disengage socket and bulb from lamp and separate lamp from door
From inside lamp cavity, remove screw holding trim panel to door
Remove screw holding arm rest pull cup to door
Remove hidden screws holding trim panel to door from carpeted  area at bottom of trim panel
Hold bottom of trim panel away from door and lift upward to disengage hooks holding trim to top of door
Separate trim panel from door

I hope this helps you out.
Roland