QuestionI have a 1940 plymouth that has not been started in at least 10 years. I have driven the car before so i know it runs but like i said hasn't been started in 10 years. Should the gas tank be removed and emptied of any fuel including the gas line. Also I read in another post that a teaspoon of oil should be put in each cylinder, should I do anything else as to not ruin the engine thanks in advanced.(this car has not been modified in any way)
Dan Windsor ont
AnswerMy routine for these Rip Van Winkle cars is as follows provided that the engine will turn over and is not stuck:
1. Change the oil and filter if equipped.
2. Remove the spark plugs and pour about a teaspoon full of oil in each cylinder.
3. Install new spark plugs.
4. Remove the distributor and install new points, condenser , and rotor.
5. Inspect and replace as needed distributor cap and wires.
6. Install outside fuel source.
7. Install a correct fully charged battery. In this case a 6 volt.
8. I prime the fuel system with a propane torch. That is a torch with the burner head removed and the metering valve removed but the control valve and stem left on. Hold the open end of the tube in the carburetor inlet and open the valve when cranking the engine. As the carburetor fills and fuel is available you should be able to turn the propane off.
9. Run the engine long enough to get the oil pressure up and then shut it down. After you make sure that it runs on all cylinders then service the fan belt, cooling system, and anything else.
Good Luck
