Dodge Repair: 2005 dodge wheel bearing assembly, dodge ram 1500, wheel bearing

Question
how do you change the front hub assembly on a 2005 dodge ram 1500 with abs? 5.7 litre

Answer
HUB/BEARING - 4X2
Raise and support the vehicle.
Remove the wheel and tire assembly.
Remove the brake caliper and rotor (Refer to 5 - BRAKES/HYDRAULIC/MECHANICAL/ROTORS - REMOVAL).


1 - HUB/BEARING  
2 - DUST SHIELD  
3 - STEERING KNUCKLE  
4 - WHEEL SPEED SENSOR WIRE  
5 - HUB/BEARING MOUNTING BOLT  


Remove the ABS wheel speed sensor if equipped (4), (Refer to 5 - BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR - REMOVAL)(HUB/BEARING 4X2)
Remove the three hub/bearing mounting bolts (5) from the steering knuckle (3)(HUB/BEARING 4X2).
Slide the hub/bearing (1) out of the steering knuckle (3)(HUB/BEARING 4X2).
NOTE: The next step excludes SRT-10. (SRT-10 does not have a dust shield)

Remove the brake dust shield (2) (HUB/BEARING 4X2).