Dodge Repair: 2006 dodge caravan -bumper removal, fascia brackets, 2006 dodge caravan

Question
How do I remove the rear bumper of my 2006 dodge caravan ? Thanks.

Answer
. Open liftgate.
2. Remove attaching screw from upper fascia to the liftgate tower, right side and left side.
3. Hoist and support vehicle with safety stands.

4. Disconnect rear park assist wire connector Fig. 1 , if equipped.


Fig. 1 - PARK ASSIST WIRE CONNECTOR  


5. Remove the three screws attaching rear fascia to rear fascia brackets on right side and left side Fig. 2 and Fig. 3 .
6. Remove the four plastic push pin attaching bottom of rear fascia to fascia support.
7. Remove rear fascia from vehicle by lifting sides of fascia up and outboard to release from rear fascia brackets.


Fig. 2 - REAR BUMPER FASCIA  
1 - REAR FASCIA  
2 - PUSH PINS  
3 - REAR BUMPER REINFORCEMENT  
4 - REAR FASCIA BRACKET  



Fig. 3 - REAR FASCIA WITH PARK ASSIST SENSOR  
1 - SIDE TRIM  
2 - STEP PAD  
3 - REAR FASCIA  
4 - PARK ASSIST SENSOR  



8. Remove park assist sensor Fig. 4 , if necessary. (Refer to 08 - Electrical/8B - Chime/Buzzer/Chime/Buzzer/SENSOR, Park Assist - Installation) .


Fig. 4 - PARK ASSIST SENSOR  
1 - PARK ASSIST SENSOR  
2 - LOCKING CLIP