Dodge Repair: Window Regualtor Drivers Side 2000 Dakota Dodge, power mirror, door latch

Question
How do i install a window regulator on drivers side of 2000 Dodge dakota? V8

Answer
FRONT DOOR TRIM PANEL
REMOVAL
Release door latch and open door.
Roll window down.
Remove window crank Window Crank - Typical , if equipped.
Remove screws attaching trim panel to door Door Trim Panel and Trim Panel Screw
CAUTION: Do not forcibly pull trim panel from door, damage to trim panel may occur.

Simultaneously lift upward and outward to release retainer steps from inner door panel Trim Panel Retainer
Disengage inside handle linkage rod from inside handle.
Disconnect speaker harness wire connector Speaker And Power Mirror Connector
Disengage power mirror wire connector, if equipped (driver's side only) Speaker And Power Mirror Connector
Disengage clips attaching power window/lock switch panel to door trim panel. Disengage wire connector from switch panel, if equipped Power Door Lock/Window Connector
Separate door trim panel from vehicle.
INSTALLATION
Position trim panel at door.
Engage wire connector for window/lock switch panel, if equipped. Engage clips attaching power window/lock switch panel to door trim panel.
Engage power mirror wire connector, if equipped.
Connect speaker harness wire connector.
Engage inside handle linkage rod to inside handle.
Align trim panel retainer steps with inner door panel and slide trim panel into place.
Install screws attaching trim panel to door.
Install window crank, if equipped


FRONT DOOR WINDOW REGULATOR
REMOVAL
Remove door trim panel.
Remove water dam as necessary to access window regulator.
Remove glass from door.
Disengage power window motor wire connector from door harness, if equipped Power Regulator
Loosen bolts in slotted holes attaching regulator to door inner panel Power Regulator Bolts
Remove bolts attaching window regulator to inner door panel.
Extract window regulator through access hole in inner door panel.
Separate window regulator from door panel.
INSTALLATION
Position regulator in door and align bolts with slotted holes in door inner panel.
Install bolts attaching window regulator to inner door panel.
Engage power window motor wire connector to door harness, if equipped.
Install glass in door.
Install outer belt weatherstrip.
Install inner belt weatherstrip.
Install water dam.
Install door trim panel.
Verify operation.