Dodge Repair: Door panel removal, dodge grand caravan, grand caravan

Question
How do I remove door panel on drivers side on my Dodge Grand Caravan 97 model?
A couple days ago the window on the driver side simply fell into the door (while vehicle was parked on the parking lot). I suspect solenoid or motor failure.
Please help.
Regards
Brian

Answer
FRONT DOOR TRIM PANEL
REMOVAL
Using a trim stick (C-4755), pry courtesy lamp from door trim.
Disengage wire connector from courtesy lamp.
If equipped, remove screws holding door assist handle to inner door panel.
If equipped, remove screw holding door pull cup to inner door panel.
If equipped, remove screws holding trim panel to door from below map pocket.
If equipped, remove window crank.
Using a trim stick, remove screw cover from switch panel.
Remove screws holding switch panel to door trim.
Separate power accessary switch from door trim Front Door Switch Panel
Disengage power switch from wire connector.
If equipped, using a small, flat bladed pry tool, remove memory seat/mirror switch and disengage wire connector Memory Seat/Mirror Switch
If equipped, remove screw holding door trim to door panel from behind inside latch release handle.
Disengage clips holding door trim to door frame around perimeter of panel Front Door Trim Panel
Lift trim panel upward to disengage flange from inner belt molding at top of door.
Tilt top of trim panel away from door to gain access to latch linkage.
Disengage clip holding linkage rod to inside latch release handle Inside Door Handle Linkage
Separate linkage rod from latch handle.
Separate front door trim panel from vehicle.