Questionmy rear defrost led light flashes non stop and the ac button led dosnt light up. the ac system works fine as far as i can tell but im sick of the lights blinking/not working. this happened after having the little blue "module" box changed cuase the 4 wheel system wasnt working. the computer was recalibrated as the dealer. THANKS A BUNCH.
AnswerDIAGNOSIS AND TESTING - REAR WINDOW DEFOGGER SYSTEM
For circuit descriptions and diagrams, refer to Rear Window Defogger in Wiring Diagrams. The operation of the electrically heated rear window defogger system can be confirmed in one of the following manners:
Turn the ignition switch to the On position. While monitoring the instrument panel voltmeter, set the defogger switch in the On position. When the defogger switch is turned On, a distinct voltmeter needle deflection should be noted.
Turn the ignition switch to the On position. Set the defogger switch in the On position. The rear window defogger operation can be checked by feeling the rear window or outside rear view mirror glass. A distinct difference in temperature between the grid lines and the adjacent clear glass or the mirror glass can be detected within three to four minutes of operation.
Using a 12-volt DC voltmeter, contact the rear glass heating grid terminal A (right side) with the negative lead, and terminal B (left side) with the positive lead (Rear Window Glass Grid Test). The voltmeter should read battery voltage.
The above checks will confirm system operation. Illumination of the defogger switch indicator lamp means that there is electrical current available at the output of the rear window defogger logic and timer circuitry, but does not confirm that the electrical current is reaching the rear glass heating grid lines.
If the defogger system does not operate, the problem should be isolated in the following manner:
Confirm that the ignition switch is in the On position.
Ensure that the rear glass heating grid feed and ground wires are connected to the glass. Confirm that the ground wire has continuity to ground.
Check the fuses in the Power Distribution Center (PDC) and in the junction block. The fuses must be tight in their receptacles and all electrical connections must be secure.
When the above steps have been completed and the rear glass heating grid is still inoperative, one or more of the following is faulty:
Rear window switch (HVAC Control Assembly).
Rear window grid lines (all grid lines would have to be broken or one of the feed wires disconnected for the entire system to be inoperative).
If setting the defogger switch to the On position produces a severe voltmeter deflection, check for a short circuit between the rear window switch defogger relay output and the rear glass heating grid
