QuestionI need to remove the interior door panel from my passenger side slider door, and my passenger side rear quarter panel. How can I do this?
AnswerREMOVAL
Remove sliding door upper frame molding.
If removing the left sliding door trim panel, remove screw from inside ash receiver bezel.
Remove screw from pull cup.
Disengage push-in fasteners holding trim to door panel around perimeter and upper edge of door (SLIDING DOOR TRIM PANEL).
Remove sliding door trim panel from vehicle.
back panel
REMOVAL
CAUTION: Disconnect the negative cable clamp from battery post. Damage to accessory feed circuit can result.
Remove first row seat.
Remove second row seat, if equipped.
Remove front door sill plate on three door vehicle.
Remove sliding door sill plate on four door vehicle.
Remove left quarter trim bolster.
Remove C-pillar trim panel.
Remove left D-pillar trim panel.
Remove first row seat belt anchor.
Remove second row seat belt anchor on long wheel base vehicle.
Remove screws attaching quarter trim to quarter panel from bolster area.
Remove screws attaching rear edge of quarter trim to attaching bracket or inner quarter trim panel.
Disconnect wire connector from accessory power outlet, if equipped.
Remove quarter trim from quarter panel.
Pass front seat belt and turning loop through slot in quarter trim panel on three door vehicle.
Pass first row seat belt through slot in quarter trim panel.
Pass second row seat belt, if equipped, through slot in quarter trim panel on long wheel base vehicle.
Remove quarter trim panel from vehicle.
