Question2004 Lincoln aviator i replace the window regulator, and i need to know how to program it, if using one touch button window close and rolls down 5 inches if open the window all the way down it comes back up 2 inches, i have to not use the onetouch to close the window
How do i reprogram the windows regulator ?
thank you
AnswerNOTE: Steps 1 through 6 must be completed within 30 seconds. The entire procedure must be completed within 5 minutes.
Start with the ignition key in the OFF position and with the LF door open.
Turn the ignition key to the ON position.
Press the front window control switch (LF) to the AUTO position 6 times (AUTO up or AUTO down).
Turn the ignition key to the OFF position and make sure the LF door is open.
Press the front window control switch (LF) to the AUTO position 6 times (AUTO up or AUTO down).
Turn the ignition key to the ON position and close the LF door. The LF window glass will move down-up-down-up approximately 2-3 mm (0.1 in). This down-up-down-up movement indicates that the LF window motor has entered initialization mode.
Pull and hold the front window control switch (LF) to the UP position until the window glass stalls into the upper header seal.
Momentarily press the front window control switch (LF) to the DOWN position and release. The window will carry out a one-touch down operation until the window glass stalls at the bottom of travel stop designed into the window regulator.
Pull and hold the front window control switch (LF) to the UP position. Continue to hold the switch until after the window glass stalls into the upper header seal and carries out the down-up movement. This down-up movement approximately 2-3 mm (0.1 in.) indicates that the LF window motor has been successfully initialized.
Verify correct operation of the LF window by carrying out a one-touch down, one-touch up, proportional down, and proportional up. If the window does not operate correctly, carefully repeat this procedure.
hope this helps... -b-
